Free shipping & returns worldwide#
Sticker Fab  F1 / Rear Fog Light Overlay  - 2015-2025 Subaru WRX / STI
  • Sticker Fab F1 Rear Fog Light Overlay for 2015 - 2025 Subaru WRX/STI
  • Sticker Fab F1 Rear Fog Light Overlay for 2015 - 2025 Subaru WRX/STI
  • Sticker Fab F1 Rear Fog Light Overlay for 2015 - 2025 Subaru WRX/STI
  • Sticker Fab F1 Rear Fog Light Overlay for 2015 - 2025 Subaru WRX/STI

Sticker Fab F1 / Rear Fog Light Overlay - 2015-2025 Subaru WRX / STI

$5.00  $2.00
Save: 60% off

In Stock

Please Choose:

Shipping: Free Standard Shipping

Delivery: Cheap and fast delivery

Returns: Free Exchanges for 30 Days

Payments:

Product Detail

F1 Rear Fog Light Overlay: Our 'standard' materials are great for the job. They can make your rear F1 or rear fog light a bit darker, much darker, or red. Sourced from US distributors and made in America or Germany (Oracal). Note: The photos are on a dark lens. Light smoke is about half as dark as 'dark'. Installation: Clean your hands and the installation area. Keep soapy water handy to adjust the overlay if the alignment is off. Push out all water and air with your fingers after finding the right spot. Try our StickerFab Application Fluid for perfect application. Just a little soap in the water is enough. You can use it on the lens and the back of the overlay. Keep a hair dryer or heat gun to speed up drying. But use light heat to avoid damaging the material.


How to use: First, clean your hands and the area where you'll install the overlay. Then, get some soapy water ready. If the alignment of the overlay isn't right at first, you can use the soapy water to slide it into place. Once it's in the perfect spot, use your fingers to push out all the water and air. You can also add our StickerFab Application Fluid for a better application. Precautions: The water only needs a small amount of soap. You can apply the soapy water to both the lens and the back of the overlay. When using a hair dryer or heat gun to speed up drying, be careful. If the heat burns you, it can damage the material, so use light heat. Maintenance advice: Keep the overlay clean. If it gets dirty, you can gently clean it with soapy water and a soft cloth.


Copyright (C) hoconicear.com 2025 All Rights Reserved.