Noble STI Style Mod 1 High Back Paint Matched Duckbill Spoiler Subaru WRX 22-25

Noble STI Style Mod 1 High Back Paint Matched Rear Spoiler

Fitment: 2022 - 2025 Subaru WRX

Features:

• Modified OE styling for a unique look
• Factory paint matching, no need for extra painting
• Easy and ready-to-install right out of the box

Noble has tweaked the great OE style. This spoiler has no center dip and follows a classic duck bill style. You don't have to search for a good paint shop. Just order from us, and it's ready to install.

While the factory only offered one color, we offer a full range for a distinct appearance.

Installation

Prepare the application area. Make sure it's clean, free of dust, debris, wax, and not freshly ceramic coated (unless you use mechanical fasteners). You can install this spoiler with 3M adhesive and/or mechanical fasteners.

The 3M needs an installation temperature of 70 - 80 degrees. It forms a solid bond in 24 hours and a full bond in 72 hours.

Get someone to help test fit the spoiler before actual installation. Note the correct position. Apply 3M to the spoiler and remove the ends of the 3M backing tape. Leave enough so you can pull it out when you put the spoiler back on.

Apply the promoter before final installation. Reposition the spoiler correctly and remove all the 3M backing tape. Press down firmly.

NOTE: Screws are only for additional support with 3M. If using screws, tighten them by hand as you're drilling through the plastic spoiler.

This Noble STI Style Mod 1 High Back Paint Matched Duckbill Spoiler is made for 2022 - 2025 Subaru WRX. It has a modified OE style with no center dip, following a classic duck bill look. The paint is matched at the factory, so you don't need to find a paint shop. Just order and it's ready to install. To install, first clean the area where you'll put the spoiler. Make sure it's free of dust, debris, wax, and not freshly ceramic coated (unless you use screws). You can use 3M adhesive or screws or both. The 3M needs a temperature between 70 - 80 degrees. It starts to bond in 24 hours and fully bonds in 72 hours. Get someone to help test fit the spoiler before putting it on for real. Mark the right position. Put 3M on the spoiler and remove the ends of the backing tape. Leave enough so you can pull it out later. Apply the promoter before the final install. Put the spoiler in the right place and remove all the backing tape. Press it down hard. Remember, if you use screws, they're just extra support with the 3M. Tighten them by hand because you're drilling through plastic. For maintenance, just clean it regularly with a mild car cleaner.