Some customers asked for a more intricate overlay compared to our initial version that only covered the orange reflector. This new overlay extends slightly over the top, like an eyebrow. You'll get a pair of overlays. We highly recommend a wet installation. These overlays are available in light smoke and dark smoke colors. They're more durable against power washing and automatic car washes, and they can still be removed. First, clean the headlight surface. Place the overlay in the corner near the door and work towards the front. A water - soap mix for wet installation is ideal as it lets you slide the overlay into position. Use your fingers or a soft tool to remove bubbles. It's best to let the vehicle sit in the sun for a while. Once dry, you can power wash or use an automatic car wash. You can use a hairdryer on low heat to dry the water and position the vinyl perfectly, but don't use too much heat as it can damage the vinyl.
Using these headlight overlays is easy. First, make sure to clean the headlight surface thoroughly. For installation, we suggest a wet method with a water - soap mix. Start by placing the overlay in the corner near the door and gradually work your way to the front. You can slide it into the right position easily with this wet method. Use your fingers or a soft tool to get rid of any bubbles. After installation, let your car sit in the sun for a bit. Once it's dry, you can use power washing or an automatic car wash as these overlays are resistant. If you want to speed up the drying process, use a hairdryer on low heat. But be careful not to use too much heat as it can burn the vinyl. These overlays are available in light and dark smoke colors, and they're removable when you need to take them off.
