Torque Solution Adj Rear Lower Inner Control Arm Bushings WRX / STI 2008+ / BRZ 2013+ | TS-SU-455

Part #: TS-SU-455. Torque Solution's adjustable control arm bushings are made of 75a durometer polyurethane with stainless steel pins. They replace the soft OEM inner rubber that deteriorates over time. These bushings offer improved traction and reduced wheel hop with minimal vibration. The kit uses offset pins, providing approximately +/- 1 degree of camber and is confirmed to fit OEM rear LCA's. Only 1 kit is needed per car. Key benefits include eliminating wheel hop and traction loss, improving 60ft times and ETs, having 75A durometer bushings, getting camber adjustment from offset pins, and a limited lifetime warranty. Fits Subaru Impreza 2008 - 2014, WRX 2008 - 2014, STI 2008 - 2014, WRX 2015+, STI 2015+, Forester 2008 - 2013, Forester 2014+, BRZ 2013+, Scion FR - S 2013+, and Toyota 86 2013+. Note: An alignment is recommended after installation. Proposition 65 requires warnings for Californians about chemical exposures. WARNING: (http://www.p65warnings.ca.gov)

Using these Torque Solution control arm bushings is simple. Just replace the old OEM rubber bushings with these new polyurethane ones. Remember, you only need one kit per car. After installation, it's very important to get an alignment done. This will ensure your car drives smoothly and the bushings work as intended. To maintain these bushings, there's not much you need to do. Just keep an eye on them during regular car check - ups. If you notice any unusual wear or problems, get them inspected. And because these bushings come with a limited lifetime warranty, you can have peace of mind knowing they're built to last. Also, be aware of the Proposition 65 warning about chemical exposures in California.