FactionFab Front Stainless Steel Brake Lines Subaru WRX 2002-2005 | 1.10098.1

Fitment: Subaru WRX 2002 - 2005. On this page, you'll find the Faction Fab F-Spec Stainless Steel Brake Lines. These lines are a great upgrade from the factory rubber ones. Factory rubber lines can get soft and expand over time, but these stainless steel brake lines offer a more direct response from the brake pedal to the caliper. This not only boosts your confidence in the braking system but also improves stopping performance. Construction details: They have a PTFE Teflon inner liner to carry the fluid, a stainless steel woven middle layer for support, and an outer PCV clear abrasion - resistant coating. This coating helps prevent chaffing, protects the inner layers, and provides stress relief at fitting locations. Features: Each line is tested to withstand a 4500psi burst pressure. The stainless steel precision - machined fittings ensure a perfect fit and resist corrosion. By eliminating soft rubber lines that are prone to swelling and deforming, you'll get increased pedal feedback. These lines are 100% model - specific for a perfect fit and come with hardware. They are for the front location of your vehicle.

Using these Faction Fab F - Spec Stainless Steel Brake Lines is straightforward. First, make sure your vehicle is parked on a flat surface and the engine is off. Carefully remove the old factory rubber brake lines. Then, install the new stainless steel lines using the included hardware. Ensure all fittings are tightened properly. As for maintenance, regularly check the lines for any signs of damage like cuts or leaks. If you notice any issues, replace the line right away. Also, keep the lines clean to prevent dirt and debris from causing abrasion. When driving, be aware that these lines offer a more direct braking response compared to the factory rubber lines, so you may need to adjust your braking habits slightly at first.