The Professional JDM Rear Fog Light Kit is a top - notch accessory for your 2022 - 2024 Subaru WRX. Note that JDM and CAN vehicles have different wiring from USDM ones. Even if the connectors fit, the lighting may not work as expected. This kit comes with amazing features. It's a multi - function lamp that serves as both F1 Brake and Parking light. The plug - and - play wiring harness makes installation a breeze. High - output LEDs ensure bright illumination. Its aftermarket design with a bold bar around the outside gives your car a more modified look. All the required installation hardware is included. In Japan, Subarus get a factory rear fog light, but US vehicles have a cheap plastic block - off plate. Upgrade your vehicle with this JDM - style rear fog light to enhance the rear end. The F1 Rear Fog Lamp has smart functions. The F1 function is great for getting attention during emergency braking. In traffic, it has a built - in delay. If the brakes aren't released for 5 seconds, the lamp goes to solid illumination, avoiding constant blinking. You can enable or disable the F1 blinking behavior as you like, with instructions provided. The parking light function offers extra illumination, especially in foggy conditions due to its low - mounted position. There are comparison and installation videos available. Installation is easy with the plug - and - play harness and included hardware. Just lay out the hardware and harness, install the lamp, find a wiring route to prevent water intrusion, plug in the harness, and test the functions.
Using this rear fog light kit is quite straightforward. For the F1 function, it will grab the attention of drivers behind you during emergency braking. But in traffic, it has a built - in delay. If you keep the brakes pressed for less than 5 seconds, the lamp will stay solid instead of blinking. You can choose to turn on or off the F1 blinking feature according to your preference using the provided instructions. The parking light function will give you extra light in foggy situations. When it comes to installation, first, lay out all the hardware and the wiring harness. Then, install the lamp carefully. Make sure to find a good route for the wiring so that water won't get into your vehicle. After that, plug in the harness and test all the functions. As for maintenance, regularly check the LEDs to make sure they are working properly. Clean the lamp with a soft cloth to keep it looking good. Also, remember the note about the wiring difference between JDM/CAN and USDM vehicles. If you face any lighting issues, it could be due to this wiring mismatch.
