Fitment: This spoiler is specifically designed for 2022 - 2025 Subaru WRX models. Features: The Noble RD1 Style rear spoiler has a sleek duck - bill design. It's lightweight, tough, and built to last. It combines great looks with aerodynamic performance, giving your VB WRX a cool racing appearance. It comes with a paint - matched finish and clearcoat, and it's ready to install right out of the box. It attaches to the OEM trunk, and 3M double - sided adhesive is included. Installation: The bolts provided can be used with the factory STI holes in the trunk. If you have an OEM spoiler, you'll need to widen the holes a bit. But these bolts aren't necessary for installation. Make sure to seal any bare metal to prevent rust. Prepare the application area by removing dust, debris, wax, and avoid freshly ceramic - coated surfaces. The 3M adhesive requires an installation temperature of 70 - 80 degrees. It forms a solid bond in 24 hours and full bond in 72 hours. Have someone help you test - fit the spoiler first. Note the correct position. Apply 3M to the spoiler, remove the ends of the backing tape, and expose enough to pull it out later. Reposition the spoiler, check bolt alignment, start the bolts but don't tighten yet. Remove all the 3M backing tape, press down firmly for 30 seconds on each part of the spoiler. Open the trunk, finish tightening the bolts, and reassemble the trunk cover. California Prop 65 Warning: Working on a vehicle can expose you to harmful chemicals like engine exhaust, carbon monoxide, phthalates, and lead. Minimize exposure by avoiding exhaust fumes, idling only when needed, servicing in a well - ventilated area, and wearing gloves or washing hands often. For more info, visit www.p65warnings.ca.gov.
Using your Noble RD1 Style Trunk Spoiler: First, make sure your 2022 - 2025 Subaru WRX is the right fit for this spoiler. Before installation, clean the area where you'll attach the spoiler. Remove any dust, debris, or wax. If the area has been freshly ceramic - coated, wait until it's okay to install. The installation temperature should be between 70 - 80 degrees. You can use the 3M double - sided adhesive included. If you want, you can also use the bolts with the factory STI holes in the trunk, but they're not required. Just note that if you have an OEM spoiler, you'll need to widen the holes a bit. Have someone help you test - fit the spoiler to find the right position. Then, apply the 3M to the spoiler, remove a bit of the backing tape, and put the spoiler in place. Pull out the rest of the backing tape and press down firmly for 30 seconds on each part. After that, open the trunk, finish tightening the bolts if you're using them, and reassemble the trunk cover. The 3M will form a solid bond in 24 hours and a full bond in 72 hours. Maintenance: Keep an eye on the spoiler for any signs of damage. If you see any bare metal, seal it right away to prevent rust. Also, be careful when washing your car around the spoiler to avoid knocking it loose. And remember, working on your vehicle can expose you to harmful chemicals. So, try to minimize your exposure by following the California Prop 65 guidelines.
