Fitment: This rear spoiler is a perfect fit for Subaru WRX models from 2022 to 2025. Features: The Noble RD3-style duckbill rear spoiler, crafted from carbon fiber, is a blend of form and function. It's lightweight, durable, and easy to install, promising long - lasting performance. With an aerodynamic design, it gives your VB WRX a race - ready look that makes you stand out. The spoiler has a glossy carbon fiber finish with a clear coat. It arrives ready to install and can be attached to the OEM trunk. 3M double - sided adhesive is included for the installation. Installation: The bolts provided are for use with the factory STI holes in the trunk. If you have an OEM spoiler, you'll need to slightly widen the holes. However, these bolts aren't mandatory for installation. Remember to seal bare metal with sealant to prevent rust. Prepare the application area by ensuring it's free of dust, debris, wax, and not freshly ceramic - coated. The spoiler can be installed using just 3M, which requires an installation temperature of 70 - 80 degrees. It forms a solid bond after 24 hours and a full bond after 72 hours. Have someone help you test - fit the spoiler before starting the actual install. Note the correct position, apply 3M to the spoiler, and remove the ends of the 3M backing tape. Put the spoiler back in place, double - check bolt alignment, and start the bolts without tightening. Remove all the 3M backing tape, press down firmly on the spoiler for 30 seconds along each section. Open the trunk, finish tightening the bolts, and reassemble the trunk cover.
Using your Noble RD3 - style carbon fiber duckbill rear spoiler is easy. First, check if it fits your 2022 - 2025 Subaru WRX. When installing, you can choose to use the bolts with the factory STI holes in the trunk or just rely on the 3M double - sided adhesive. If using the bolts and you have an OEM spoiler, you'll need to make the holes a bit wider. But don't worry, the bolts aren't a must - have for installation. Before applying the spoiler, make sure the area on the trunk is clean, without dust, debris, wax, or a fresh ceramic coating. The 3M adhesive works best at 70 - 80 degrees. It'll start to hold well after 24 hours and be fully bonded after 72 hours. It's a good idea to have someone help you test - fit the spoiler first to find the right position. When it comes to maintenance, keep the spoiler clean by washing it gently with mild soap and water. Avoid using abrasive cleaners that could damage the glossy carbon fiber finish. Check the bolts and adhesive regularly to make sure they're still secure. If you notice any signs of rust on the bare metal parts, re - apply the sealant right away. With proper care, your rear spoiler will keep your car looking great for a long time.
