Part #: STF - ULOGB - WRX2015. If you're eager to make your WRX stand out compared to a standard one, these overlays are an affordable and stylish choice. They're a breeze to install! These overlays are designed to go over the painted fender vent area below the WRX or STI logo, making the fender vent more noticeable. Sold as a set, only one set is needed per vehicle, and fender emblems are not included. Installation is straightforward. First, clean the painted surface of the fender vent. Then, apply water or a soapy water mix to the area and the vinyl. This lets you adjust the product's position without it bunching up due to the adhesive. Once positioned, use your finger to press the vinyl down. Avoid using a squeegee as it can damage the vinyl. You can press out the water with your fingers. Using heat from a heat gun or hair dryer can help the adhesive bond and stretch the product to fill gaps. Start with low heat and learn how it affects the vinyl. A good rule is, if you wouldn't heat your fingers to that temperature, don't heat the vinyl to it.
Using these fender overlays is super easy. First, clean the fender vent surface thoroughly. Then add some water or soapy water to both the surface and the vinyl. This helps you move the overlay around until it's in the right place. Press it down with your finger instead of a squeegee to avoid damaging the vinyl. You can use your fingers to push out the water. When it comes to heat, a heat gun or hair dryer can be useful. Start with low heat to see how the vinyl reacts. Don't use high heat right away. As for maintenance, keep the overlays clean. You can wash them gently with mild soap and water. Avoid using harsh chemicals as they might damage the vinyl. If you notice any dirt or debris, clean it off as soon as possible to keep the overlays looking great.
