Part #: STF-ULOMB-WRX2015. If you're eager to make your WRX stand out more compared to a standard one, these overlays offer an affordable way to add style. They're super easy to install! These overlays are designed to be placed over the painted fender vent area below the WRX or STI logo, making the fender vent more prominent. Sold as a set, only one set is needed per vehicle, and fender emblems are not included. For installation, first clean the painted surface of the fender vent. Apply water or a soapy water mixture to both the area and the vinyl. This lets you adjust the product's position without it bunching up due to the adhesive. Once positioned, use your finger to press the vinyl down. Avoid using a squeegee as it can damage the vinyl. You can press out the water with your fingers. Using heat from a heat gun or hair dryer can help the adhesive bond and stretch the product to fill gaps when positioning. Start with low heat and see how it affects the vinyl. If it's too hot for your fingers, it might be too hot for the vinyl!
These fender overlays are a great way to add style to your WRX or STI. First, make sure you clean the painted surface of the fender vent before starting the installation. Then, apply some water or a soapy water mix to both the fender vent area and the vinyl. This will let you move the overlay around and get it in the right position without it sticking too soon. When you've got it where you want it, use your fingers to press the vinyl down. Don't use a squeegee because it can scratch the vinyl. You can press the water out just with your fingers. If there are any gaps, you can use a heat gun or a hair dryer to help the vinyl stretch and fill them. But start with low heat and be careful not to over - heat it. As for maintenance, just wash it gently with mild soap and water like you would the rest of your car. Avoid using harsh chemicals or abrasive materials that could damage the vinyl.
