Special Edition F1 rear fog light overlay. These are the most unique light - transmitting tint products. They're of super - high quality, making your car stand out. The Dark Galaxy design is dark yet light - transmitting. The galaxy overlay material is amazing with intense sparkle. When the light is off, the dark film makes the lens almost disappear, but it transmits a good amount of light when on. Not all materials are the same. These special edition materials are made in the USA and are high - quality, which is why they're not cheap. We're very careful when cutting them. Instructions: Clean your hands and the installation area. Keep soapy water handy to adjust the overlay if the alignment is off at first. After finding the right position, use your fingers to push out water and air. Note: The water only needs a little soap. You can use it on the lens and the back of the overlay. Keep a hair dryer or heat gun to speed up drying, but use light heat to avoid burning the material.
Using this rear fog light overlay is easy. First, make sure your hands and the area where you'll install the overlay are clean. Have some soapy water nearby. If you don't get the alignment right at first, you can use the soapy water to slide the overlay into place. Once it's in the sweet spot, use your fingers to push out all the water and air. Remember, the soapy water only needs a small amount of soap. You can apply it to both the lens and the back of the overlay. To speed up the drying process, you can use a hair dryer or a heat gun. But be careful not to use too much heat as it can damage the material. If it feels too hot on your skin, it's too hot for the overlay. As for maintenance, keep the overlay clean by gently wiping it with a soft cloth. Avoid using harsh chemicals as they can harm the material.
