Part #: 15WRX - F1 - DSHC. This special edition F1 rear fog light overlay stands out in the market. It's a high - quality light - transmitting tint product that makes your car unique. The dark smoke honeycomb design is dark yet effectively transmits light. The materials are made in the USA, ensuring top - notch quality. They're not inexpensive as we're very meticulous in cutting them. High - quality materials justify the cost. Installation is straightforward. First, clean your hands and the installation area. Have some soapy water handy to adjust the overlay if the alignment is off at first. After finding the right position, use your fingers to push out all the water and air. Remember, the soapy water only needs a small amount of soap and can be used on the lens and the back of the overlay. You can use a hair dryer or heat gun to speed up drying, but use light heat to avoid damaging the material.
Using this rear fog light overlay is easy. First, clean your hands and the area where you'll install the overlay. Get some soapy water with just a little soap in it. If the overlay doesn't line up right at first, use the soapy water to slide it into place. Once it's in the sweet spot, use your fingers to push out all the water and air bubbles. You can use a hair dryer or heat gun to dry it faster, but don't use too much heat as it might damage the material. When it comes to maintenance, just keep the overlay clean. You can use a gentle cleaner and a soft cloth to wipe it down. If it gets dirty, clean it as soon as you can to keep it looking great and working well.
