Sticker Fab Special Edition Dark Smoke Stealth Headlight Overlays - 2015-2021 WRX / STI

Part #: 15WRXHLDSST. These special edition dark smoke carbon fiber headlight overlays are for 2015+ WRX/STI models. Made with pride in the USA, this high - quality material isn't cheap. It lets light pass through while giving your vehicle a cool, dark stealthy look. If you love matte finishes, this mod is a must - consider. They're super easy to install and can amazingly change your vehicle's appearance. INSTRUCTIONS: First, clean and wet the overlay and headlight surface with a mix of one drop of dishwasher soap and water. This helps with alignment. Place the overlay in the right spot and squeegee out the water with your fingers to prevent damage. Use your nails to make sure the edges stick. It's a good idea to use a heat gun on low or a hair dryer to boost the vinyl's adhesion. The soapy water reduces adhesion for proper alignment, and the heat dries the water. It also helps wrap the material around tough bends at the edges. Let the overlay stick to the headlight for 24 hours. Once dry, they'll hold up in automatic car washes and against most power washing.

Using these headlight overlays is easy. First, mix one drop of dishwasher soap with water and use this solution to clean and wet both the overlay and your headlight. This makes it easier to place the overlay in the right position. Put the overlay on the headlight and use your fingers to push out the water. You can use your nails to make sure the edges are well - attached. After that, you can use a heat gun on a low setting or a hair dryer. This helps the vinyl stick better by drying out the soapy water and allows it to wrap around the edges nicely. Remember to let the overlay sit for 24 hours so it fully sticks to the headlight. Once it's dry, you don't have to worry much. These overlays can handle automatic car washes and most power washing. Just avoid using very abrasive materials when cleaning your car to keep the overlays in good condition.